Skip to main content
Loading…
This section is included in your selections.

The following standards apply to construction within the R-3 zone:

Minimum

lot size

6,000 square feet

lot width

60 foot average

lot frontage

60 feet

Lot area/unit

3 or more bedrooms

3,000 square feet

2 bedrooms

2,500 square feet

1 bedroom

2,000 square feet

Lot area/unit for properties adjacent to commercial zoned

3 or more bedrooms

2,000 square feet

1 to 2 bedrooms

1,250 square feet

Front yard setback

Building less than 15 feet high within first 40 feet from front property line

5 feet

Building less than 25 feet high within first 40 feet

10 feet

Building over 25 feet high within first 40 feet

15 feet

Side yard setback

For buildings 15 feet high or less in height

5 feet

For buildings 16-25 feet high

10 feet

For buildings over 25 feet high

15 feet

Rear yard setback

Abutting another lot

20 feet

Abutting a street

15 feet

Abutting water, an alley or private way

10 feet

Setback for conditional use

10 feet, or minimum for that yard, whichever is greater

Maximum lot coverage

Structures, excluding uncovered decks, etc.

40 percent (increases to 50 percent in cases of multiple-family housing adjacent to open water and/or adjacent to commercial zoned properties)

Total coverage

60 percent

Maximum height

36 feet above grade

Usable open space

200 square feet/unit/public

300 square feet/unit/private

Off-street parking

1.25 spaces per apartment of 2 or fewer bedrooms

2 spaces per apartment of 3 or more bedrooms

2 spaces minimum per detached single-family dwelling unit

4 spaces minimum per detached two-family dwelling

For residential uses, must be located on same lot, or within 300 feet of dwellings for which parking is required.

For all other permitted uses, within 500 feet of use.

For duplex and multiple-family dwellings, in closed garage or covered carport.

For nonresidential uses, may be in open lot, if landscaped and approved by the Planning Commission.

For all regulations concerning the determination and measurement of slope, height; setbacks, floor area ratio and other development standards, see Chapters 19.44 through 19.68 inclusive, of this Title. (Ord. 2011-4 § 27, 2011; Ord. 89-1 § 1, 1989.)